Firmware Updates

TX-NR929

Notice of Firmware Update for TX-NR929

A firmware update for the TX-NR929 network A/V receiver is available through the unit's USB input. The latest update includes the following content:

Latest Firmware Number (16 digits):1040-8110-2000-0101


As of 24 September 2015

  • Improve Spotify Connect operation.
  • Improve audio output of DTS-HD Master Audio with a particular Blu-ray disc.

As of 18 December 2014

  • Adds support of Spotify Connect;
  • * Please download the Spotify Music app from the iTunes or Google Play store prior to installing this update.
  • * After installing this update, Spotify will no longer be able to be controlled through the receivers OSD menu.
  • * All control of the Spotify service will be done through the Spotify Music app.

As of 19 February 2014

  • Corrects the sound distortion problem when switching between High/Low Distance in Digital Processing Crossover Network Set Up;

As of 3 December 2013

  • Corrects the problem of not being able to connect to Free Trial on SiriusXM Internet Radio
    *SiriusXM is only available in USA or CANADA

As of 1 October 2013

  • Adds support of Control4® Simple Device Discovery Protocol;

As of 28 August 2013

  • Improves picture output of 4K up-scaling;
  • Corrects problem where a hidden SSID could not connect when selecting "Direct Input" in manual wireless LAN setup;

How to Check if Your Firmware Version is Up To Date

To Check if your firmware is up to date, go into Home Menu -> Firmware Update and check the 12-digit number (xxxx-xxxx-xxxx). If any numbers differ from the latest version available, please update your unit.

Precautions for TX-NR929 Firmware Update

  • Please read the update instructions carefully before beginning.
  • The firmware update should take 30 to 40 minutes. Once the update begins, don't turn off the power supply to the A/V receiver until it is time to restart it.
  • Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish. If the update is not completed within two hours, turn off the power supply by pushing the ON/STANDBY button and then try updating again from the beginning.
  • Updating the firmware and adjusting the settings will be done automatically, but may take some time to complete. Please follow the procedures as instructed when you update. Note that the update may fail, or cause problems for your A/V receiver, if you do any of the following:
  • Pull out the A/V receiver’s power cord;
  • Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an electrical outage);
  • Insert or remove the LAN cable from a device in your network when updating over a network;
  • Insert or remove a USB memory device from the A/V receiver when updating via USB;
  • Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device.

If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee.

How to Install Firmware Update for TX-NR929

Click below for instructions on how to install the update.

Click below to download the firmware update to your PC, for subsequent installation on your receiver via its USB port.

Please click here for the details about Open Source Software.