A firmware update for the TX-NR515 / TX-NR515AE / HT-R791 network A/V receiver is available through the unit’s network connection or USB input. The latest update includes the following content:
|Information Concerning Firmware Update for Onkyo Network Receivers|
Onkyo has discovered there is a possibility of failure when updating receivers to this new firmware package via ethernet in certain network environments. For this reason, we are now only releasing a firmware file for installation via USB port / flash memory device.
Users should first check to see if their network receiver is running the latest firmware (1130-9106-0300 or 1130-9106-0301 released August 10, 2012) before installing this update via USB. If your network receiver is not running firmware version 1130-9106-0300 or 1130-9106-0301, please update your receiver to this version via the network facility before proceeding further.
If your receiver is running more newer firmware, there is no need to update via network facility. You can judge whether older or newer by the first three digits.
To check your firmware version, press the “Home” button on your remote control. Highlight “F/W Update” or select the “Firmware Update” icon and press enter. Your current firmware version will be displayed on the front panel of your A/V receiver as well as your TV screen.
Should you encounter any difficulties when performing this update, please contact us.
We appreciate your understanding and apologize for any inconvenience this issue may cause.
Additional Audio file format
■ Apple Lossless (.m4a/.mp4/.M4A/.MP4)
Sampling rates of 8 kHz, 11.025 kHz, 12 kHz, 16 kHz, 22.05 kHz, 24 kHz, 32 kHz, 44.1 kHz, 48 kHz, 64 kHz, 88.2 kHz and 96 kHz are supported.Quantization bit: 16 bit, 24 bit
■ DSD (.dsf or .DSF)
The sampling rate of 2.8224 MHz is supported.
■ Dolby True HD (.vr/.mlp/.VR/.MLP)
Sampling rates of 48 kHz, 64 kHz, 88.2 kHz, 96 kHz, 176.4 kHz and 192 kHz are supported.
※Playing Dolby True HD files at rear USB port is not supported.
※Notice; Limitation of when using UWF-1
1. Only 64 kHz and less sampling rate is supported;
2. Dolby TrueHD and DSD is not supported;
3. Using at rear USB port is not supported;
Note:If you already have applied Remote APP ver1.30, the following restriction will be occur.
■Android / iOS
In APP menu you can select Home Media Function, but does not operate in AV Receiver.
When playing music contents that saved in the iPod touch/iPhone at AV receiver via network, the sound stutter may occur.
** see below for further details;
*All Setting will be cleared after this update. Initial set-up must be performed again including Audyssey calibration.
*It is also necessary to update the App.
To Check if your firmware is up to date, go into Setup -> Hardware Setup -> Firmware Update and check the 12-digit number (xxxx-xxxx-xxxx). If any numbers differ from the latest version available, please update your unit.
If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee.